HP LaserJet Enterprise, HP LaserJet Managed, HP PageWide Enterprise, HP PageWide Managed - Configuration Guide using the Embedded Web Server (EWS)
Step one: Set up the sign-in methods
The Access Control sign-in methods can be enabled for the printer, but only one can be the default sign-in
method. If more than one method is enabled, access the non-default method from the printer control panel by
touching Sign In, and then touch Advanced.
●
Windows sign-in setup
●
LDAP sign-in setup
NOTE: If an HP Smart Card Reader solution is installed, disable all other sign-in methods on this page because
signing in is required with this solution. Install certicates on the Certicate Management page if required.
Sign-in methods
● Windows
● LDAP
● Installed third-party sign-in solutions – See the documentation that came with the third-party solution for
information about setting up that sign-in method.
Windows sign-in setup
Use the following steps to set up Windows sign-in.
1. Using the EWS top navigation tabs, click Security.
2. In the left navigation pane, click Access Control.
3. To congure the Windows sign-in method, click the Setup link for this method on the Access Control page.
4. Select the Enable Windows Sign In (Kerberos and NTLM) check box.
5. Add Windows domains to be recognized by the printer:
a. Enter the Fully Qualied Domain Name (FQDN) or IP address in the Trusted Domains eld.
b. Click Add.
Enter the fully-qualied host name or an IP address in dotted-decimal notation.
NOTE: If DNS settings are not set appropriately, a fully-qualied domain name might be required.
By default, the rst domain added to the trusted domain list is automatically selected as the Default
Windows Domain. If other trusted domains have been added, they can be selected as the default domain in
the Default Windows Domain eld.
6. Select the Show Preferred Domain Servers check box to create a list of preferred domain servers.
The specied Preferred Domain Servers will be used rst, and if these servers do not work, the rmware
will nd domain servers based on the Trusted Domains list.
a. Enter the FQDN or IP address in the Preferred Domain Servers eld.
b. Click Add.
7. Verify the match and retrieval default attributes and update if necessary.
52 Chapter 5 Congure printer security ENWW