HP LaserJet Managed MFP E72425, E72430, E72525, E72530, E72535 - Spacer Accessory Installation Guide

Installation Guide

3 4

Unpackage the HP LaserJet Spacer (Y1G24A), two HCI supports

and retain the two “L” shaped brackets for securing the HP

LaserJet spacer to the DCF or HCI.

Remove the casters, stabilizer feet, and stabilizer brackets from

the bottom of the DCF or HCI.

Using a manual screwdriver install the casters to the bottom

of the HP LaserJet spacer. The screw holes for the casters are

pre-threaded.

Using a manual screwdriver, install the stabilizer brackets to the

bottom of the HP LaserJet Spacer. Install stabilizer feet into each

bracket.

NOTE: The four screw holes for each stabilizer bracket are not

pre-threaded. You will need to apply downward force as you

install each screw.

5 6

If the spacer will be installed on the HCI perform steps 6 thru 10.

If installed on the DCF go to step 11.

Locate the two HCI supports and remove from packaging. The

front and rear are clearly marked.

x 2

Y1G24A

HP LaserJet Spacer

PAGE 1
Y1G24A HP LaserJet Spacer x2 x2 Installation Guide 1 2 Unpackage the HP LaserJet Spacer (Y1G24A), two HCI supports and retain the two “L” shaped brackets for securing the HP LaserJet spacer to the DCF or HCI. 3 Remove the casters, stabilizer feet, and stabilizer brackets from the bottom of the DCF or HCI. 4 Using a manual screwdriver, install the stabilizer brackets to the bottom of the HP LaserJet Spacer. Install stabilizer feet into each bracket.
PAGE 2
7 8 2 1 1 On the spacer remove six screws from the front (1) and rear (2) covers. Three are located on the outside and three more on the bottom. NOTE: You may need to loosen the rear side cover screws to release the rear cover. 9 Remove two screws from the front support and remove. Install HCI front support with two screws. Move two sliver alignment pins (1) to new HCI support. 10 2 1 Remove four screws from the rear support and remove. Install HCI rear support with four screws.