HP LaserJet Managed MFP E72525, E72530, E72535, E72825, E72830, E72835 - Engine Install Guide

NJ
OE
3
3.2
4
4.1
4.3
4.2
4.4
4.6
4.5
4.84.7
Carefully lift the printer assembly and align the printer to the alignment
pins and connector on the accessory. Carefully lower the printer onto
the accessory.
CAUTION: The printer assembly is heavy. Four people must lift and
install it on the DCF, the HCI, or the stand.
NOTE: On the printer, open each door and all of the trays to check for
shipping tape and packing materials. Remove all shipping tape and
protective packing materials.
Remove all packing material and tape from all locations on the engine.
Locate the shipping label instruction tab on the
right door.
Open the right door and then remove the shipping
label directing you to the transfer area.
Carefully remove the strapping tape at the front of the
transfer unit.
Remove the foam packaging material. Carefully remove the strapping tape at the rear of the
transfer unit.
Open Tray 1 on the right side of the printer, and then
remove the foam near the pickup roller.
Open Tray 2-3 and remove all tape and foam
packaging material.
Remove the scanner lock screw and red sticker on the
left side of the printer.
WARNING: The scanner lock screw must be removed
prior to powering on the printer.
TopazOnly_Engine_IG 4languages_.indd 3 3/1/2019 8:23:12 PM