HP LaserJet Managed MFP E72525, E72530, E72535, E72825, E72830, E72835 - Engine Install Guide

8
12
Late point dierentiation conguration (LPDC) checklist (manually using USB ash drive).
• Make sure that the network cable is disconnected from the printer.
• Turn on the main power switch (near the power cord), and then press the power button on the front of the printer to turn the power on.
• Download the speed license to a USB ash drive.
• With an internet-connected PC, open a browser and go to the HP Jet Advantage Management (JAM) Activation site: https://activation.jamanagement.hp.com
• Select the country/region.
• Select SIGN IN on the Partner First Portal.
• Type the HP Passport sign-in credentials (including the User ID and Password).
• Select Managed Print Specialist.
• Select Technical Support.
• Select Activate License.
• Search for License.
• Enter the Serial Number and Printer Product Number.
• Select Submit.
• Select the Get License button next to the device serial number to download the LPDC license le.
NOTE: If the license is not found, contact your distributor to ensure HP has been sent the information to create the license. Once HP has created the license you
will need to wait 24-48 hours before the license becomes available in the cloud.
CAUTION: Licenses must be saved in the root directory of the USB drive with the specied le name.
• Save the le to the root directory of the USB ash drive that has been FAT32 formatted.
• With the printer at the Ready state, insert the USB ash drive into the walk-up USB port on the printer (formatter or HIP USB).
• Make sure that the control panel acknowledges that a USB ash drive is installed (a quick message appears on the control panel). Then, press the power
button on the front of the printer to turn the power o.
• Press the power button on the front of the printer to turn the power on, and then wait for the printer to reach the Ready state.
NOTE: If the USB ash drive is not detected, remove the USB ash drive, turn the printer power o, reinsert the USB ash drive, and then turn the printer power on.
• Wait for the LPDC process to automatically start (within 10 minutes of having a working internet connection).
NOTE: The printer reboots after the LPDC process is complete, and then the printer setup wizard starts.
• When the Setup Wizard appears, recongure each of the settings.
• Wait at least 5 minutes after the printer comes to a Ready state to allow the LPDC process to complete.
CAUTION: Do not turn the printer power o during this time.
• Print another conguration page and make sure that the LPDC is congured with the correct license speed and that the printer model number is correct.
The printer product model changes to the ordered model number. In the LPDC status, the rst number in the parentheses (x) is either “0”, “1” or “2”. The “0”
corresponds to the slowest speed, “1” is the middle speed, and “2” is the fastest speed. This conrms that the LPDC process is complete.
• Connect the network cable.
NOTE: If the manual license transfer fails, contact your distributor for support.
TopazOnly_Engine_IG 4languages_.indd 8 3/1/2019 8:23:19 PM