HP MFP Analog Fax Accessory 700 - Fax Guide

Fax Settings
Fax Send Settings
Fax Send Setup
Fax Dialing Settings
Congure any of the following settings:
Menu item Description
Line Monitor Volume Use the Line Monitor Volume setting to control the printer's dialing volume level when
sending faxes.
Dialing Mode The Dialing Mode setting sets the type of dialing that is used: either tone (touch-tone
phones) or pulse (rotary-dial phones).
Fax Send Speed The Fax Send Speed setting sets the modem bit rate (measured in bits per second) of the
Analog Fax modem while sending a fax.
Fast (v.34 – 33.6k)
Medium (v.17 – 14.4k)
Slow (v.29 – 9.6k)
NOTE: Medium is the default value.
Redial Interval The Redial Interval setting selects the number of minutes between retries if the number
dialed is busy or not answering, or if an error occurs.
Redial On Error The Redial On Error feature sets the number of times a fax number will be redialed when
an error occurs during a fax transmission.
Redial On Busy The Redial On Busy setting selects the number of times (0 through 9) the fax accessory
redials a number when the number is busy. The interval between retries is set by the Redial
Interval setting.
Redial On No Answer The Redial On No Answer setting selects the number of times the fax accessory redials if
the number dialed does not answer. The number of retries is either 0 to 1 (used in the U.S.)
or 0 to 2, depending on the country/region setting. The interval between retries is set by
the redial interval setting.
Detect Dial Tone The Detect Dial Tone setting determines whether the fax checks for a dial tone before
dialing to send a fax.
Dialing Prex The Dialing Prex setting allows you to enter a prex number (such as a "9" to access an
outside line) when dialing. This prex number is automatically added to all phone numbers
when dialed.
FutureSmart 4
1. From the Home screen on the printer control panel, select Settings.
2. Open the following menus:
Fax
Fax Send Settings
Fax Dialing Settings
10 Chapter 4 Change fax congurations ENWW