HP MFP Analog Fax Accessory 700 - Fax Guide

Menu item Description
Error Correction Mode Normally, the fax accessory monitors the data on the telephone line while it is sending or
receiving a fax. If the fax accessory detects an error during the transmission and the Error
Correction Mode setting is on, the fax accessory can request that the error portion of the
fax be sent again.
The Error Correction Mode feature is enabled by default. You should turn it o only if you
are having trouble sending or receiving a fax and if you are willing to accept the errors in
the transmission and a probable quality reduction in the image. Turning o the setting
might be useful when you are trying to send a fax overseas or receive one from overseas,
or if you are using a satellite telephone connection.
NOTE: Some VoIP providers might suggest turning o the Error Correction Mode setting.
However, this is not usually necessary.
Fax Header Use the Fax Header feature to control whether the header is appended to the top, and
content is shifted down, or if the header is overlaid on top of the previous header.
Fax receive settings
FutureSmart 3
1. From the Home screen on the printer control panel, scroll to and select the Administration button.
2. Open the following menus:
●
Fax Settings
●
Fax Receive Settings
●
Fax Receive Setup
Congure any of the following settings:
Menu item Description
Ringer Volume Select the Ringer Volume drop-down menu and adjust the ringer volume settings.
Rings To Answer The Rings To Answer setting determines the number of times the phone rings before the
call is answered by the fax accessory.
NOTE: The default range for the available options for the Rings To Answer setting is
specic to the country/region. The range of possible Rings To Answer options is limited by
country/region.
If you experience problems with the fax accessory answering, and the Rings To Answer
setting is 1, try increasing it to 2.
Fax Receive Speed Select the Fax Receive Speed drop-down menu and select one of the following options:
●
Fast (v.34 – 33.6k)
●
Medium (v.17 – 14.4k)
●
Slow (v.29 – 9.6k)
NOTE: Medium is the default value.
Ring Interval
1
Select the box beneath the Ring Interval heading to open the keypad. Enter a value for the
ring interval on the keypad, and then select the OK button. The default setting for ring
interval is 600 ms.
ENWW Fax receive settings 13