HP MFP Analog Fax Accessory - Warranty and Legal Guide

Declaration of conformity
Declaration of Conformity
according to ISO/IEC 17050-1 and EN 17050-1
Manufacturer's Name: HP Inc. DoC #: BOISB-0703-01- R1 Original/en
Manufacturer's Address: 11311 Chinden Boulevard
Boise, Idaho 83714-1021, USA
declare, under its sole responsibility that the product
Product Name and Model:
2)
HP Analog Fax Accessory 700
Regulatory Model Number:
1)
BOISB-0703-01
Product Options: All
conforms to the following Product Specications and Regulations:
EMC: CISPR 22:2008 Class A
CISPR 32:2012 / EN 55032:2012 Class A
3)
EN 55024:2010
FCC CFR 47 Part 15 Class A
3)
ICES-003, Issue 6 Class A
3)
SAFETY: IEC 60950-1:2005 +A1:2009 +A2:2013
EN 60950-1:2006 + A11:2009 +A1:2010 +A12:2011 +A2:2013 /+AC:2011
IEC 62479:2010 / EN 62479:2010
RoHS: EN 50581:2012
Telecom: ES 203 021-1 v2.1.1 / ES 203 021-2 v2.1.2 / ES 203 021-3 v2.1.2; FCC Rules and Regulations 47 CFR Part 68
The product herewith complies with the requirements of the Low Voltage Directive 2014/35/EU, the EMC Directive 2014/30/EU, the RoHS Directive
2011/65/EU and carries the marking accordingly.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Additional Information:
1. This product is assigned a Regulatory Model Number which stays with the regulatory aspects of the design. The Regulatory Model Number is the
main product identier in the regulatory documentation and test reports, this number should not be confused with the marketing name or the
product numbers.
2. This product was tested in a typical HP environment.
3. The product meets the requirements of EN 55032 Class A, in which case the following applies: 'Warning – This is a Class A product. In a domestic
environment this product may cause radio interference in which case the user may be required to take adequate measures'.
4. Wired telecom approvals and standards appropriate for the target countries/regions have been applied to this product, in addition to those listed
above.
Boise, Idaho 09, 30 2017
Rich Payne, Manager LES Product Regulations
Local contact for regulatory topics only:
28 Chapter 3 Regulatory information ENWW