HP MFP Analog Fax Accessory - Warranty and Legal Guide

Telekomdeklaration (fax)
Information om faxkabel
Produkten kanske levereras med en faxkabel. Om ingen faxkabel ingår bör endast en kabel med AWG-värde 26
eller högre användas.
EU-bestämmelser för telekommunikation
Skrivaren uppfyller gällande EU-direktiv och har CE-märkning. Mer information nns i EU-
Överensstämmelseförklaringen, som givits ut av tillverkaren, i ett annat avsnitt av den här handboken.
För skrivare som kan anslutas till PSTN (Public Switched Telecommunication Networks):
På grund av skillnader mellan enskilda, nationella PSTN i Europa går det inte att garantera att en åtgärd för
produkten fungerar felfritt på alla PSTN-slutpunkter. Nätverkskompatibiliteten är beroende av att kunde väjer
rätt inställning när de förbereder för att ansluta till PSTN. Följ instruktionerna som anges i handboken. Om du
upplever problem med nätverkskompatibiliteten kontaktar du din utrustningsleverantör eller HP:s support i
landet/regionen där produkten används. Den lokala PSTN-operatören kan ha angett ytterligare krav för att
ansluta till en PSTN-slutpunkt.
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item
will work correctly in all respects with another item of Telepermitted equipment of a dierent make or model, nor
does it imply that any product is compatible with all of Telecom’s network services.
This equipment may not provide for the eective hand-over of a call to another device connected to the same
line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back
of this equipment is a label that contains, among other information, a product identier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not
all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed
to be connected to the telephone network or premises wiring using a compatible modular jack, which is Part 68
compliant. This equipment cannot be used on telephone company-provided coin service. Connection to Party
Line Service is subject to state taris.
SVWW Telekomdeklaration (fax) 33