HP MFP Analog Fax Accessory - Warranty and Regulatory Reference Guide

Положения в области телекоммуникационного (факсимильного)
оборудования
Обязательство для кабеля факса
В комплект поставки устройства может входить или не входить кабель факса. Если кабель факса не входит
к комплект поставки, для уменьшения риска пожара используйте только телекоммуникационный кабель
№26 AWG или больше.
Положение ЕС для телекоммуникационных операций
Принтер соответствует требованиям применимых Директив ЕС и снабжен маркировкой CE.
Дополнительные сведения см. в выпущенной производителем «Декларации соответствия нормам ЕС» в
другом разделе данного руководства.
Для принтеров с функцией подключения к аналоговым коммутируемым телефонным сетям общего
пользования (ТСОП):
Вследствие различий Европейских национальных телефонных сетей общего пользования нельзя
полностью гарантировать успешную работу изделия в любой точке подключения к ТСОП. Совместимость с
сетью зависит от правильности настройки параметров, выполняемой пользователем при подготовке к
подключению к ТСОП. Необходимо следовать инструкциям, приведенным в руководстве пользователя.
Если у вас возникли проблемы с сетевой совместимостью, обратитесь к поставщику оборудования или в
службу поддержки HP Inc. в стране эксплуатации устройства. Подключение к ТСОП может подпадать под
дополнительные требования, устанавливаемые местным оператором ТСОП.
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item
will work correctly in all respects with another item of Telepermitted equipment of a dierent make or model, nor
does it imply that any product is compatible with all of Telecom’s network services.
This equipment may not provide for the eective hand-over of a call to another device connected to the same
line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back
of this equipment is a label that contains, among other information, a product identier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not
all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
RUWW Положения в области телекоммуникационного (факсимильного) оборудования 35