HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide
Technical site setup
Table 3-1 Technical site setup worksheet
Yes/No Notes
Will the MFP physically t based
on the operating size
specication where it will be
installed?
❑
Yes
❑
No
See Specications on page 19.
HP recommends that the installation site also support the Serviceability Space
Requirements that allows for 18 inches (457.2 mm) of servicing space on all four sides.
Equipment can be repositioned during the service visit to accommodate the Service Space
Requirements.
Is the oor level? (optional)
❑
Yes
❑
No
See Specications on page 19, weight specs.
Is the oor stable? (optional)
❑
Yes
❑
No
See Specications on page 19, weight specs.
Is there any carpeting or
ooring that requires protection
or reinforcement?
If yes, what is the length of
ooring requiring covering?
❑
Yes
❑
No
Thick carpeting can cause misalignment between the MFP and Finisher.
Is required power available on a
dedicated circuit in the direct
vicinity?
US, EMEA, and AP require one
power outlet for the printer.
Or, is a power outlet in the direct
vicinity rated to supply the
specic conguration?
❑
Yes
❑
No
The outlet needs to be within 6 feet of planned location of MFP. If a new dedicated circuit
needs to be run, work with customer to complete prior to installation.
See Specications on page 19 for more information and check the order to conrm any
specic power requirements.
NOTE: HP recommends installing the printer on its own circuit to prevent possible
interference from other devices.
Does the room meet the
Environmental Specications?
❑
Yes
❑
No
See Specications on page 19.
Is there a network connection in
the direct vicinity?
❑
Yes
❑
No
Be sure that it is Ethernet.
Will there be direct sunlight on
the MFP?
❑
Yes
❑
No
Is there suicient cooling?
❑
Yes
❑
No
See Specications on page 19.
Is there proper air ventilation?
(optional)
❑
Yes
❑
No
Has the customer IT approved
the installation? (optional)
❑
Yes
❑
No
12 Chapter 3 Worksheets ENWW