HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide
NOTE: The LPDC status should read: LPDC Congured.either a (0), a (1), or a (2).
If not internet connection is available or the LPDC process is not possible via the network connection, the
speed license can be downloaded to the USB ash drive and then manually transferred to the printer.
Download the speed license manually (USB ash drive)
1. Make sure the network cable is disconnected from the device.
2. Press the power switch on the front of the device, wait for the device to power o, and then turn of the
main power switch on the device.
3. Download the speed license to the USB ash drive.
a. With an internet connected PC, open a browser and go to the HP Jet Advantage Management (JAM)
Activation site https://activation.jamanagement.hp.com/redirect?ReturnUrl=%2F#!/.
b. Type the HP Passport sign in credentials including the UserID and password.
c. Wait to be directed back to the JAM Activation site and then type the following information:
NOTE: If the following information is available, type the individual serial number and either the
generic model number “X3AxxA” or ordered speed model number “X3AxxA”, or the “Z8Zxx” speed
model.
If the model and serial number is not available and the customer number and SAP PO number are
known, it can also be entered here.
●
Sold to number or CBN (customer number).
●
SAP order number.
d. Select the Get license button next to the device SN# to download the LPDC license le.
NOTE: Use the ‘edit nd’ function to quickly nd the device’s serial number.
e. Save the le to the root directory of the USB ash drive that has been FAT32 formatted.
4. Transfer the license information with the device at ready state, then what you have in A.
a. With the device at a Ready state, insert the USB ash drive into the walk up USB port on the device
(formatter or HIP USB).
b. Make sure the control panel acknowledges that a USB ash drive has been installed (a quick message
will appear on the control panel), then turn the device OFF.
c. Turn the device ON, and then wait for the device to reach a Ready state.
NOTE: If the USB ash drive is not detected, remove the USB ash drive, turn device o, reinsert the
USB ash drive, and then try again.
d. Wait for the LPDC process to complete (1–2 minutes).
e. Wait for the device to reboot automatically.
f. When the Setup Wizard displays, re-congure each of the settings.
5. Wait another 5 minutes to allow the device to nish the LPDC process.
ENWW LPDC installation steps 57