HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

HP LaserJet MFP E72525, E72530, E72535 with a DCF and HP
LaserJet Spacer installation checklist
Click here to view a video of this procedure.
Please review the LaserJet A3 videos for a complete understanding of the installation of each device. Use these
checklists as a reminder of the steps demonstrated in the videos.
CAUTION: The engine assembly is heavy and requires a four person lift.
NOTE: Ensure the DCF, 2000-sheet HCI, are prepared and ready for engine to be placed on top.
Table 8-1 Delivery and installation checklist
❑
Unpack the DCF (dual cassette feeder).
❑
Unpack the spacer.
NOTE: The spacer is required if an external nishing device will be attached to the device.
❑
Remove the casters, stabilizer feet and stabilizer feet brackets from the bottom of the DCF.
❑
Add the stabilizer feet and casters to the bottom of the spacer.
NOTE: The screw holes for the stabilizer feet brackets are pre-threaded. Use a manual screw driver and apply downward force
when installing the self-tapping screws.
❑
Using two people, lift and carefully place the DCF on top of the spacer.
❑
Install two brackets at rear to secure the DCF to the spacer.
❑
Remove the packing foam and tape from the DCF.
❑
Set aside the tray numbers labels for installation later.
❑
Be sure to remove the foam shipping block located behind the trays.
❑
Unpack MFP.
❑
Remove the packing foam and tape.
CAUTION: The device weighs 68kg (150 lbs).
❑
Use four people to lift the device and carefully place on top of the DCF..
❑
Remove the remaining tape and packing foam from the trays.
❑
Remove the package containing the image unit and set aside.
❑
Remove the scanner lock screw and label and install the screw cover.
❑
Open the right door and remove the shipping label directing you to the transfer area.
❑
Remove the strapping tape located at the front of the transfer unit.
❑
Remove the foam block from the transfer unit.
❑
Remove the strapping tape located at the rear of the transfer unit.
❑
Close the right door and open the MP tray (Tray 1).
❑
Remove the foam shipping block from the MP tray (Tray 1).
❑
Unpack the toner cartridge and locate the two seals.
❑
Pull DOWN to remove the seal on the bottom. Pull OUT and remove the seal at the rear.
76 Chapter 8 Complete installation procedures ENWW