HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

Table 8-1 Delivery and installation checklist (continued)
❑
Shake the toner cartridge to distribute the toner.
❑
Open the front door and install the toner cartridge.
❑
Push IN on latches on each side to remove the TCU (toner collection unit).
❑
Open the right door.
NOTE: This step is required to retract the interlock at the imaging unit opening.
❑
Unpack the imaging unit.
❑
Remove the white protective cover.
CAUTION: Do not touch the green surface of the drum unit.
❑
Pull OUT to remove the orange charge roller shipping lock.
❑
Remove the plug and the tape from the imaging unit vent area.
❑
Pull straight OUT to remove the seal at the front of the imaging unit.
❑
Hold the imaging unit with one hand on the bottom and the other hand on the gray handle at the front of the imaging unit.
❑
Align the bottom of the imaging unit to the bottom of the opening and slide the imaging unit into the device.
❑
Push IN while installing the rst screw at the top of the imaging unit.
❑
Install the second screw at the top of the imaging unit.
❑
Connect the imaging unit cable to the front of the MFP.
❑
Route the cable inside the channel at the front of the MFP.
❑
Close the right door.
❑
Install the TCU.
❑
Remove the protective lm from the logo on the front door.
❑
Apply the tray number labels.
❑
Install the stabilizer blocks.
NOTE: Not required if an external nisher is attached to the device.
❑
Perform Late Point Dierentiation and Conguration (LPDC).
❑
Apply the “XA3” barcode inside of the front door and nameplate on the front door of the device.
❑
Upgrade the rmware with latest available on hp.com.
❑
Insert a thumb drive with rmware at the connector on the control panel.
❑
Select the following: Support Tools > Maintenance > USB Firmware Upgrade
NOTE: All accessories must be attached when upgrading rmware.
NOTE: Accessories added later will NOT be upgraded automatically..
Install the DCF on the HP Color LaserJet MFP E77822, E77825, E77830
Click here to view a video on this procedure.
CAUTION: The engine assembly is heavy and requires four people to lift.
ENWW HP LaserJet MFP E72525, E72530, E72535 with a DCF and HP LaserJet Spacer installation checklist 77