HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

ManualsBrandsHP ManualsDesktopsHP Color LaserJet Managed Flow MFP E77830z - Speed 30 ppm

Table 8-3 On-site nal setup tray heater in the HP LaserJet MFP E82540, E82550, E82560 (continued)

❑

Reinstall trays 2 and 3 into the device.

❑

Plug the MFP into the power outlet and power the device on.

How to install the tray heater in the E7 (mono) MFP (not shown in a video)

Please review the LaserJet A3 videos for a complete understanding of the installation of each device. Use these

checklists as a reminder of the steps demonstrated in the videos.

CAUTION: The engine assembly is heavy and requires four people to lift.

NOTE: The installation of the tray heater in the 2000-sheet HCI and dual cassette feeder (DCF) are similar.

Table 8-4 On-site nal setup tray heater in the HP LaserJet MFP E82540, E82550, E82560

❑

Power down and unplug the MFP.

CAUTION: Unplugging the device is MUST because the tray heaters are ALWAYS energized if the power cord is plugged in and the tray

heater switch is ON.

❑

Unpack the tray heater.

❑

Remove tray 2 and 3 from the device.

❑

Note the cable connector on the tray heater.

❑

Note the tabs on the rear of the tray heater.

❑

Connect the cable from the tray heater to the connector on the rear wall of the MFP.

❑

Insert the tabs on the rear of the tray heater into slots in the rear wall of the MFP.

❑

Locate the tray heater power switch in the rear of the tray opening.

❑

Turn the switch ON to apply power to the tray heater(s).

❑