HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

HP LaserJet Second exit and bridge (IPTU) on the HP LaserJet MFP
E72525, E72530, E72535
Click here to view a video of this procedure.
CAUTION: The engine assembly is heavy and requires four people to lift.
Please review the LaserJet A3 videos for a complete understanding of the installation of each device. Use these
checklists as a reminder of the steps demonstrated in the videos.
NOTE: The bridge is included with the Stapler/Stacker or Booklet Maker nisher.
NOTE: The 2nd exit must be ordered separately when installing a nishing option for an E7 device.
Table 8-6 On-site nal setup 2nd exit and bridge
❑
Power down the MFP.
❑
Open the right door.
❑
Remove ve screws and remove the upper right side cover.
TIP: Move the power button cover slightly forward to release the side cover.
❑
Remove two screws on the left side of the power button cover.
❑
Rotate the power button cover toward the front to expose the frame behind.
❑
Remove one screw and remove the 2nd exit dummy cover.
❑
Remove the two paper settling guides from the rst exit.
❑
Gently lift the hook and remove the bin full actuator from the 1st exit.
NOTE: Remove the bin full actuator if installing the inner nisher or bridge. Leave the bin full actuator installed if the face-down
output bin will be used.
❑
Remove two screws at the front of the face-down bin (one screw requires a “stubby” JIS#2 driver).
❑
Use small at blade screwdriver to pry o the top left cover.
❑
Pull UP on the left and then remove the face-down bin.
❑
Unpack the 2nd exit assembly. Remove the blue tape to expose the 2nd exit bin full sensor actuator.
❑
Remove the 2nd exit bin full actuator when installing a bridge.
NOTE: Leave the 2nd exit bin full actuator attached if you’re installing an inner nisher or a job separator.
❑
Align the pin at the rear of the 2nd exit assembly with the hole on the rear wall of the chassis.
❑
Rotate the 2nd exit assembly into place against the bracket on the front wall of the chassis.
❑
Install one screw at the front and one screw at the rear.
❑
Connect three cables at the rear.
❑
Replace the upper right cover.
❑
Snap the power button cover back into position and install one screw on the right.
❑
Install two screws on the left side of the power button cover.
❑
Close right door.
82 Chapter 8 Complete installation procedures ENWW