HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

Table 8-7 On-site nal setup inner nisher on the HP LaserJet MFP E72525, E72530, E72535 (continued)
❑
Install the tray on the support brackets and push down rmly to seat the pins in the holes.
❑
Hold the tray from above while installing the self-tapping screws from below.
HP LaserJet Inner nisher
Install the Inner HP LaserJet Punch
Click here to view a video of this procedure.
CAUTION: The engine assembly is heavy and requires four people to lift.
Please review the LaserJet A3 videos for a complete understanding of the installation of each device. Use these
checklist as a reminder of the steps demonstrated in the videos.
NOTE: The inner punch must be purchased separately and is installed in the inner nisher. This is a checklists
for installing the inner punch into a new inner nisher.
Table 8-8 On-site nal setup inner nisher punch
❑
Unpack the inner nisher and remove all the blue packing tape.
❑
Open the inner nisher front door.
❑
Unlatch and open the jam access area (also know as the dummy punch).
❑
Remove and discard the mylar surrounding the latch handle.
❑
Use a piece of blue tape to hold the latch in the open position.
❑
Locate and remove the e-clip and plastic washer just behind the lever.
❑
Remove the blue tape, close the dummy punch and close the front door.
❑
Place the nisher front side down on a table.
❑
Locate and remove three screws on the rear cover.
❑
Use a at blade screwdriver to release the cover tab located at the lower rear corner near the cable entrance and lift the cover
slightly.
❑
Now pull along the top edge to release three tabs and remove the cover.
❑
Locate the hinge pin at the rear of the dummy punch.
❑
Remove the e-clip at the bottom of the hinge pin and remove the hinge pin.
❑
Disconnect the cable.
❑
Turn the nisher back to its normal orientation..
❑
Open the front cover.
❑
Open the dummy punch.
❑
Pull forward to remove the dummy punch from the inner nisher.
❑
Unpack the inner punch.
❑
Position the inner punch on the inner nisher and slide the cables through the chassis at the rear.
❑
Close the inner punch and the front cover.
ENWW Finishers 85