HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

Table 8-9 On-site nal setup booklet maker nisher with punch (continued)
❑
Open the front door on the nisher and remove all foam and tape inside the nisher.
❑
Pull out the booklet maker and install two staple cartridge holders in the top of the booklet maker.
❑
Slide the booklet maker into the nisher.
❑
Remove the stapler lock screw and label.
❑
Rotate the green wheel to the left until the spring loaded white tab is exposed under the stapler.
❑
Rotate the green wheel to the right until the stapler moves back to the front position and stops.
❑
While holding the green wheel, insert the staple cartridge holder into the stapler.
❑
Follow these steps to install the optional hole punch.
❑
Remove two screws and remove the punch unit access panel on the rear of the nisher.
❑
Remove two screws and remove the “dummy” punch unit.
NOTE: Save the dummy punch in the event the hole punch fails; it’s needed if the hole punch is removed.
❑
Locate the alignment pin and tab at the front of the punch unit and the mounting bracket at the rear.
NOTE: Be careful when handling the punch unit. Do not damage the mylar guides or the encoder wheel.
❑
Carefully slide the punch unit into the nisher. Align the mounting bracket at the rear.
NOTE: The punch unit is properly seated when the mounting bracket at the rear is ush against the nisher frame.
❑
Note the orientation of the pins on the connector. While supporting the connector on the nisher side, insert the hole
punch cable connector.
❑
Install one screw to secure the punch unit in the nisher.
❑
Replace the punch unit access panel and secure with two screws.
❑
Open the front door of the nisher and install the punch waste bin label.
❑
Pry the cover out of the punch waste bin opening and install the punch waste bin.
❑
Hang the lower tray support brackets on the horizontal bracket on the output side of the nisher.
❑
Secure each one with a screw.
❑
Note the alignment pins on the bottom of the tray and the corresponding holes on the support brackets.
❑
Position the tray over the brackets and push down rmly to seat the pins in the holes.
❑
While holding the tray from above, install four screws to secure the tray to the support brackets.
❑
Note the four tabs, install the upper tray into the slots.
❑
Install the front (F) and the rear (R) nisher attachment brackets on the left side of the engine.
❑
Secure with two screws in each bracket.
❑
Peel the cover o the connector near the rear bracket.
❑
Position the nisher near the left side of the engine and connect the two cables.
❑
Open the nisher front door and pull out the locking rail until it stops.
ENWW Finishers 87