HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide
Table 8-10 On-site nal setup stapler/stacker (continued)
❑
Position the nisher near the left side of the engine and connect the two cables.
❑
Open the nisher front door and pull out the locking rail until it stops.
❑
Align the brackets on the engine to the holes on the nisher and roll the nisher against the engine.
❑
Push the locking rail in and install one screw to secure the nisher to the engine.
NOTE: If the locking rail won’t slide in easily, adjust the casters on the nisher to change the height.
NOTE: Check the vertical gap between the nisher and the engine. Adjust the casters for an equal gap from top to bottom.
NOTE: Remove the nisher from the engine if the MFP needs to be moved anything more than a very short distance.
HP LaserJet Job Separator
There is no installation video available for this procedure.
User this checklist to perform the installation of the Job Separator.
NOTE: The Job Separator requires the installation of the optional HP LaserJet 2nd exit.
Table 8-11 On-site nal setup job separator
❑
Remove the tape which covers the support hole on the back wall under the scanner.
❑
Install the job separator by aligning the tabs on the right side to the holes on the second exit.
❑
Insert the left side table into the hole on the back wall under the scanner.
Staples
Click here to view a video of this procedure
HP LaserJet Inner nisher and Booklet Maker nisher rell staple cartridge product number: Y1G13A.
Replace the inner nisher staple cartridge
1. Open the staple cartridge access door.
ENWW Finishers 89