HP ProOne 400 G2 20 inch All-in-One HP ProOne 460 G2 20 inch All-in-One HP ProOne 480 G2 20 inch All-in-One - Maintenance & Service Guide

3. Lower the stand onto the computer and press down until it clicks into place (2).
Removing an easel stand
To remove the stand:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 22).
2. Remove the rear port cover (see Rear port cover on page 23).
3. Press the release latch under the stand (1).
4. Lift the stand up (2), and then pull the stand hooks out of the computer (3).
Attaching and removing a stand 27