User Guide - Windows 7

1. Select Start > All Programs > Intel > Intel Rapid Storage Technology.
2. Click the Acceleration link, and then click the Disable Acceleration link.
3. Wait for the Acceleration Mode to complete.
4. Click the Reset to Available link.
IMPORTANT: You must temporarily disable SRT when changing RAID modes. Make the change and then re-
enable SRT. Failure to temporarily disable this feature will prevent you from creating or changing RAID
volumes.
NOTE: HP does not support SRT with self-encrypting drives (SEDs).
Removing or replacing the service doors
Removing the service doors
Remove the service doors to access the memory module slot, hard drive, and other components.
1. Remove the battery (see Removing a battery on page 36).
2. With the battery bay away from you, loosen the larger service door screw (1) to release the service door.
3. Slide the larger service door toward the front of the computer (2) to remove the service door.
4. Loosen the smaller service door screw (3) to release the service door.
5. Tilt the smaller service door upward to remove the service door (4).
Using hard drives 45