HP Pavilion x360 Convertible PC (model numbers 15-bk100 through 15-bk199 and 15-bk000 through 15-bk099) - Maintenance and Service Guide

Hard drive
NOTE: The hard drive spare part kit does not include the hard drive bracket or cable. The hard drive bracket
and cable are included in the Hard Drive Kit, spare part number 808238-001.
Description Spare part number
1-TB, 5400-rpm, SATA, 7.2-mm hard drive 762990-005
500-GB, 5400-rpm, SATA, 7.0-mm hard drive 778186-005
500-GB, 5400-rpm, SATA, 8-GB hybrid, 7.0-mm, solid-state hard drive 732000-005
Before removing the hard drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 28).
5. Disconnect the battery cable from the system board (see Battery on page 33).
Remove the hard drive:
1. Release the ZIF connector (1) to which the hard drive cable is connected, and then disconnect the hard
drive cable from the system board.
2. Use the tab (2) to lift the front edge of the hard drive (3) until it rests at an angle.
3. Remove the hard drive (4) by sliding it up and forward at an angle.
4. If it is necessary to replace the hard drive bracket, separate the left and right sides of the bracket (1)
from the hard drive, and then remove the hard drive bracket (2).
Component replacement procedures 35