User Guide

14
How do I clear a paper jam?
If the printer stops feeding pages, it might be jammed. Clear paper jam and restart the printer by pressing and
holding the power button.
1. In the sprocket app, press OK to clear the error message.
2. Turn o the printer.
3. Remove the Paper Cover by sliding it away from the Output Slot. Remove any loose photo paper from the input
tray.
4. Gently remove the jammed paper from the input tray.
5. Reload the remaining photo paper with the print side facing up.
6. Align the Paper Cover with the tracks on the outside of the printer, and then slide the Paper Cover toward the
Output Slot until it is rmly seated.
8. Turn on the printer.
See page 2 of the HP Sprocket Printer User Guide for paper loading illustrations.
How do I attach a lanyard to my printer?
Attach a lanyard (sold separately) to your printer to secure the printer to your wrist, carabiner, etc.
NOTE: Make sure the lanyard contains a strap small enough to thread through the lanyard attachment point of your printer.
1. Turn o the printer and remove the top cover by sliding it away from the output slot.
2. Remove any loose photo paper from the input tray and locate the lanyard attachment point at the top of
the printer.
3. With the lanyard in one hand, thread the smaller lanyard loop through the hole in the printer until
approximately half of the lanyard is through the hole. Thread one end through the opposite end of the
lanyard.
4. Tighten the lanyard by pulling the opposite end.
5. Reload the remaining photo paper with the print side facing up, align the top cover with the tracks on the
outside of the printer and then slide the top cover toward the output slot until it is rmly seated. Turn on the
printer.