HP EliteBook Folio 1040 G3 Notebook PC - Maintenance and Service Guide

Power connector
Description Spare part number
Power connector 844424-001
Before removing the power connector, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 28).
5. Disconnect the battery (see Battery on page 29).
Remove the power connector:
1. Disconnect the power connector cable from the system board (1).
2. Remove the power connector cable from the clip built into the chassis (2).
3. Remove the Phillips PM2.0×4.0 screw (3) that secures the power connector cable to the computer.
4. Lift the power connector from the computer (4).
Reverse this procedure to install the power connector.
38 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts