Hardware Reference Guide
Attaching the stand
CAUTION: Unless the thin client is mounted with the HP Quick Release, it must be operated with
the stand attached to ensure proper airflow around the thin client.
Adjusting the stand
The stand can be adjusted into two configurations: square for the horizontal position and rectangular
for the vertical position.
Take the stand apart by removing the two short pieces connecting the two sides. Snap the sides to
the outer connection points on the short pieces for a square configuration or to the inner connection
points for the narrow configuration.
Installing the stand
The thin client can be used in either a tower or horizontal orientation with the stand included with the
thin client.
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external
devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
5. Adjust the stand, if necessary.
For instructions, go to
Adjusting the stand on page 7.
6. Attach the stand to the thin client.
●
Attach the stand to the bottom of the thin client to use the thin client in the tower orientation.
Attaching the stand 7