Hardware Reference Guide
B Removing and replacing the battery
WARNING! Before removing the access panel, be sure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external
devices.
4. Disconnect the power cord from the power outlet, and disconnect any external devices.
CAUTION: Regardless of the power-on state, voltage is always present on the system board
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the thin client.
5. Remove the thin client from the stand and lay the thin client down with the right side up.
6. Remove the thin client access panel. See
Removing and replacing the access panel on page 9.
7. Locate the battery and battery holder on the system board.
8. To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
21