Manual

Solid-state drives (M.2)
Description Spare part number
1 TB, Z Turbo drive PCIe 848366-001
512 GB, Z Turbo Drive, PCIe 848364-001
256 GB, Z Turbo Drive, PCIe 848363-001
256 GB, SATA-3, self-encrypting drive (SED), Opal 2 848365-001
512 GB, SATA-3, self-encrypting drive (SED), Opal 2 848367-001
Before removing the SSD, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see Service door on page 33).
5. Disconnect the battery (see Battery on page 34).
6. If you are removing the secondary SSD, remove the secondary hard drive (see Hard drive on page 35).
NOTE: The secondary SSD is only available if a primary SSD is installed.
Remove the SSD:
1. Remove the Phillips screw (1) that secures the solid-state drive to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Component replacement procedures 39