HP Spectre Notebook PC (model numbers 13-v100 through 13-v199) - Maintenance and Service Guide

Solid-state drive
Description Spare part number
1-TB, 2280, PCIe, 3×4, NVMe, 3LC, 1 side, SN solid-state drive 908359-002
512-GB, M.2, 2280, NVMe solid-state drive supporting TLC 855609-001
256-GB, M.2, 2280, NVMe solid-state drive supporting TLC 855608-001
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 26).
5. Disconnect the battery cable from the system board (see Battery on page 28).
Remove the solid-state drive:
1. Remove the Phillips PM1.0×2.5 screw (1) that secures the bracket to the computer.
2. Remove the bracket (2).
3. Slide the solid-state drive away from the connector to remove the drive (3).
Reverse this procedure to install the solid-state drive.
30 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts