HP Spectre Notebook PC (model numbers 13-v100 through 13-v199) - Maintenance and Service Guide

5. Remove the system board (4).
Reverse this procedure to install the system board.
Heat sink
Description Spare part number
Heat sink (includes replacement thermal material) 854752-001
Before removing the heat sink, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 26), and then remove the following components:
a. Battery (see Battery on page 28)
b. Solid-state drive (see Solid-state drive on page 30)
c. WLAN module (see WLAN module on page 31)
d. System board (see System board on page 37)
Remove the heat sink:
1. Following the 1, 2, 3 sequence stamped into the heat sink, remove the three Phillips PM2.0×3.0
screws (1) that secure the heat sink to the system board.
Component replacement procedures 39