Manual

Ceiling Mount User’s Guide
4
Ceiling Mounting Procedure:
Before installation, refer to the
“
Adjusting the Projected
Image” section of the Projector
User’s Guide for the projection
distance based upon the de-
sired image size. Use this
projection distance to locate the
ceiling mount.
Drill four holes into the structural ceiling
member.
Attach the ceiling rod to the ceiling with the
four cylinder screws.
HP recommends that a
competent carpenter or
electrician install this
ceiling mount.
Structural Ceiling
Ceiling Rod
Cylinder Screw
Ceiling Bracket
Make necessary roll and yaw adjustments to the
projector.
180°
(YAW ADJUSTMENT)
vv
vv
v
Adjust the appropriate ceiling projection image mode from the “Management” menu tab in the
on screen display.
Three Bracket Screws
Be sure to install the
projector into a solid,
structural ceiling member:
u
wx
v
Attach the ceiling bracket to the ceiling rod with
the round thumbscrew. Height adjustments can
be made by using different holes on the ceiling
rod and ceiling bracket.
vv
vv
v
The total adjustment range is15.75 to
25.6 inches (40~65cm). Adjusments can be made
in one inch (2.5cm) increments.
±60°
(ROLL ADJUSTMENT)
Round Thumbscrew
P/N 36.85807.001-A
Mount the projector to
the ceiling mount bracket
with the three bracket
screws.
±20°