Manual

Table 7 RAID Manager Error Codes (continued)
DescriptionSSB2 code
The emulation type of the S-VOL was 3390-A, and the pair operation was rejected for one of the
following reasons:
20CA
• Mainframe Fibre CHA was not mounted
• Mainframe Fibre CHA was all blocked
The P-VOL rejected the paircreate operation because the THP pool is initializing in the Thin Provisioning
or Smart Tiers V-VOL.
20D0
The S-VOL rejected the paircreate operation because the THP pool is initializing in the Thin Provisioning
or Smart Tiers V-VOL.
20D1
The pair operation was rejected because the P-VOL is used by Compatible FlashCopy SE or is a TSE
volume.
20D6
The pair operation was rejected because the S-VOL is a TSE volume.20D7
The CTG ID you specified is being used by BC and therefore cannot be used by BC Z.20DC
The pair operation was rejected because the volume you specified as the P-VOL is an external volume
that is mapped for online data migration.
20DE
The pair operation was rejected because the volume you specified as the S-VOL is an external volume
that is mapped for online data migration.
20DF
The pair operation was rejected because the volume you specified as the P-VOL was a Compatible
FlashCopy S-VOL.
22F6
The pair operation was rejected because the volume you specified as the S-VOL was a Compatible
FlashCopy P-VOL or S-VOL.
22F7
The Quick Restore or the Reverse Copy operation was rejected because the volume you specified as
the S-VOL was a Compatible FlashCopy P-VOL or S-VOL.
22F9
The pair operation was rejected because shared memory is not allocated or BC Z is not installed.2301
The pair operation was rejected because the volume you specified as the P-VOL or S-VOL was not
the top volume of the LUSE volume.
2302
The pair operation was rejected because the LBA size of the P-VOL you specified was not the same
as the size of the S-VOL you specified.
2306
The create pair operation was rejected because the number of pairs exceeded the maximum number
of pairs.
2309
The create pair operation was rejected because the volume you specified as the S-VOL was the P-VOL
of the BC Z pair whose MU number is 0.
230A
The pair operation was rejected because the pair was being suspended or deleted.230B
One of the following occurred:2310
• The create pair operation was rejected because the consistency group number you specified had
already been used for L1 pair.
• The create pair operation was rejected because the consistency group number you specified had
already been used for L2 pair.
• The create pair operation was rejected because the volume specified as the P-VOL was the S-VOL
of the pair which was being Quick Split.
• The Quick Restore operation was rejected because the VLL setting of the P-VOL was different from
that of the S-VOL.
• The pair operation was rejected because the P-VOL and S-VOLs you specified were a Compatible
FlashCopy pair.
• The Quick Restore or reverse copy operation was rejected because the pair of the P-VOL and
S-VOLs you specified are suspended (Suspend/SUSPER status).
• The Quick Restore or reverse copy operation was rejected because the P-VOL and the S-VOL you
specified was the L2 pair.
Troubleshooting with RAID Manager 61