Manual

Table 11 CESTPAIR parameters
DescriptionValueParameter
NADevice numberDEVN
These parameters must be used for successful
execution of the command.
Primary volume: SSID, serial number, channel
connection address, and CU number.
PRIM
To request the Add and Split operation, set
MSF00 instead of a serial number. This
parameter is valid for MODE(COPY) or
MODE(NOCOPY) only.
To create pairs in a consistency group, set
MAnn0 instead of a serial number. nn is a CTG
ID.
NASecondary volume: SSID, serial number,
channel connection address, and CU number.
SEC
The storage system recognizes only COPY for the
MODE parameter, even if NOCOPY is specified.
COPYMODE
NOCOPY
2
Copy speed is medium, regardless what is specified
for the PACE parameter.
Any numberPACE
Not used by BC Z.Not applicableCRIT
MSGREQ function is applicable.YES
2
MSGREQ
Note: You cannot use the MSGREQ function when
the Add and Split operation is required. Specifying
YES for this parameter when the Add and Split
operation is required rejects the command and the
command ends abnormally by reporting CC = 8.
MSGREQ function is not applicable.NO
Pair create operation is performed whether the
S-VOL is online or not.
YESONLINSEC
1
Pair create operation is not performed if the S-VOL
is online.
NO
1. When you do not specify the parameter, the result is the same as when you specify NO for this parameter.
2. If NOCOPY is specified for the MODE parameter and YES for the MSGREQ parameter, the CESTPAIR command
ends before the copy operation is completed.
CESTPAIR example
ESTPAIR
The following table describes the PPRCOPY ESTPAIR command parameters used to create pairs.
Table 12 PPRCOPY ESTPAIR parameters
DescriptionValueParameters
Only one of the three parameters should be
specified. The italic term is the arbitrary name.
DDNAME = dname = JCL statement identifying
the volume.
DDNAME,
SYSNAME, or
UNITADDRESS For example, dname is the arbitrary unique
SYSNAME = sysxxx = SYSNAME in the ASSGN
system control statement.
72 Pair operations using PPRC