Manual

Table 12 PPRCOPY ESTPAIR parameters (continued)
DescriptionValueParameters
UNITADDRESS = ccuu = device number.
name of the JCL statement which identifies the
volume.
These parameters must be used for successful
execution of the command.
Primary volume: SSID, serial number, channel
connection address.
PRI
To request the Add and Split operation, set
MSF00 instead of a serial number. This parameter
is valid for MODE(COPY) or MODE(NOCOPY)
only.
To create pairs in a consistency group, set
MAnn0 instead of a serial number. nn is a CTG
ID.
NASecondary volume: SSID, serial number, channel
connection address.
SEC
The system recognizes only COPY for the
MODE parameter, even if NOCOPY is
specified.
COPYMODE
NOCOPY
Copy speed is medium, regardless what is
specified for the PACE parameter.
1-255PACE
Not used by BC Z.Not applicableCRIT
Do not specify this parameter when
MODE(RESYNC) is set, otherwise it ends
abnormally reporting CC = 12.
YESMSGREQ
MSGREQ function is not applicable.NO
NAP-VOL or S-VOL CU number.LSS
Pair create operation is performed whether the
S-VOL is online or not.
YESONLINSEC*
Pair create operation is not performed if the
S-VOL is online.
NO
* When you do not specify the parameter, the result is the same as when you specify NO for this parameter.
ESTPAIR example
Splitting pairs with CSUSPEND and PPRCOPY SUSPEND
Split pairs using the CSUSPEND and PPRCOPY SUSPEND commands.
• The commands are issued to the P-VOL.
• The pair must be in DUPLEX status.
Parameters and examples are provided in the following section.
CSUSPEND
The following table describes the CSUSPEND command parameters used to split pairs.
Splitting pairs with CSUSPEND and PPRCOPY SUSPEND 73