Manual

SUSPEND example
Resynchronizing pairs with CESTPAIR and PPRCOPY ESTPAIR
Resynchronize pairs using the CESTPAIR and PPRCOPY ESTPAIR commands.
• The commands are issued to the P-VOL.
• The pair must be suspended (Split/SUSPOP or Suspend/SUSPER status).
Parameters and examples are provided in the following.
CESTPAIR (resynchronizing pairs
The following table describes the CESTPAIR command parameters used to resynchronize pairs.
Table 15 CESTPAIR parameters
DescriptionValueParameter
NADevice numberDEVN
These parameters must be used for successful
execution of the command.
Primary volume: SSID, serial number, channel
connection address, and CU number.
PRIM
You can set an additional parameter
corresponding to each request instead of a
serial number. If you do not set an additional
parameter, the request triggers a normal copy.
For a Quick Resync, set MRF00. This
parameter is valid for MODE(RESYNC) only.
For a Quick Restore, set MRQ00. This
parameter is valid for MODE(RESYNC) only.
For a Reverse Copy set MRR00. This parameter
is valid for MODE(RESYNC) only.
To resync all pairs in a consistency group, set
MAnn0 instead of a serial number. nn is a
CTG ID. The request triggers a normal resync
operations.
NASecondary volume: SSID, serial number,
channel connection address, and CU number.
SEC
Re-establish a split or suspended volume pair. This
parameter is required.
RESYNCMODE
Copy speed is medium, regardless what is specified
for the PACE parameter.
Any numberPACE
Not used by BC Z.Not applicableCRIT
MSGREQ function is applicable.YESMSGREQ
For a Resync request on all pairs in a consistency
group, do not use the MSGREQ function. Using the
MSGREQ function ends the job abnormally and
"CC = 8" is reported.
MSGREQ function is not applicable.NO
Resynchronizing pairs with CESTPAIR and PPRCOPY ESTPAIR 75