Manual

QUERY example
Output descriptions
The following table shows the field descriptions of the output resulting when CQUERY TSO and
QUERY ICKDSF commands are run.
Table 21 Field descriptions for CQUERY TSO and the QUERY ICKDSF command output
DescriptionField
Device number of the volume on which the CQUERY command is issued.DEVICE
PRIMARY indicates that the volume is a P-VOL. SECONDARY indicates that the volume
is a T-VOL.
LEVEL
Pair statusSTATE
Invalid for BC; Active is shown.PATH STATUS
Invalid for BC; NO is shown.CRIT
Invalid for BC; NO is shown.CGRPLB
SSID of the P-VOL CUPRIMARY-SSID
P-VOL LDEV numberPRIMARY-CCA
P-VOL CU numberPRIMARY-LSS
P-VOL serial numberPRIMARY-SERIAL
SSID of the S-VOL CUSECONDARY-SSID
S-VOL LDEV numberSECONDARY-CCA
S-VOL CU numberSECONDARY-LSS
S-VOL serial number. Running the CQUERY TSO command for the S-VOL also show
following information:
SECONDARY-SERIAL
00ab000nnnnn
where a indicates that the pair is defined as a consistency group and b indicates the
pair was split using At-Time Split. 0 indicates otherwise. nnnnn is the S-VOL serial number.
Showing pair information with CQUERY TSO, QUERY ICKDSF 81