Manual

DescriptionItem
The snapshot group name.
If you have not set a snapshot group for FS pairs, this item is blank.
For BC, BC Z and SS, a hyphen (-) is shown.
The pair status.Status
For more information, see “Pair status definitions” (page 50).
Secondary Volume
• LDEV ID: The S-VOL’s LDEV identifier.
• LDEV name: The S-VOL’s LDEV name.
• Emulation Type: The S-VOL’s emulation type.
• Capacity: The S-VOL’s volume capacity.
• CLPR: The S-VOL’s CLPR number.
• Mode: Indicates whether the S-VOL has been written to. For BC, this item also
indicates whether the S-VOL can be read.
◦ For BC:
- W is shown if the S-VOL was written to and when the S-VOL was written
to and cannot be read when its pair status is PSUS(SP)/PSUS or PSUS.
- N is shown if the S-VOL cannot be read. You have specified -m noread
using RAID Manager.
- A hyphen (-) indicates that the S-VOL has not been written to and it can
be read.
◦ For FS and SS:
- W is shown if the S-VOL was written to when its pair status is
PSUS(SP)/PSUS or PSUS.
- A hyphen (-) indicates that the S-VOL has not been written to.
◦ For BC Z:
- W is shown if the S-VOL was written to when its pair status is
V-Split/SUSPVS or Split/SUSPOP.
- Protect is shown if the S-VOL is write-protected. You specified the PROT
MODE in BCM as PROTECT when the S-VOL’s pair status was
Split/SUSPOP, SP-Pend/TRANS, or V-Split/SUSPVS.
- A hyphen (-) indicates that the S-VOL has not been written to and you
made Protect settings.
(FS and SS only.)Snapshot Date
The date and time when a snapshot was acquired.
For BC and BC Z, a hyphen (-) is shown.
The consistency group identifierCTG ID
(BC and BC Z only.)COPY Pace
The copy speed.
For FS and SS pairs, a hyphen (-) is shown.
The mirror unit number.Mirror Unit
View Pair Synchronous Rate window
Use this window to view the percentage of synchronized data between the P-VOL and S-VOL.
For detailed information, see “Monitoring synchronous rates” (page 52).
View Pair Synchronous Rate window 95