User guide

Informazioni normative
La stampante soddisfa i requisiti degli enti normativi del proprio paese/regione.
Questo capitolo tratta i seguenti argomenti:
●
Numero di modello normativo
●
Specica FCC
●
Istruzioni per il cavo di alimentazione
●
Informazioni per gli utenti residenti in Germania
●
Dichiarazione sulle emissioni acustiche per la Germania
●
Avviso normativo per l'Unione Europea
●
Dichiarazione di conformità
●
Dichiarazioni normative per le reti wireless e cablate
Numero di modello normativo
Ai ni della conformità alle norme, al prodotto è assegnato un Numero di modello normativo. È importante
non confondere tale numero di modello normativo con il nome commerciale o con il numero del prodotto.
Specica FCC
The United States Federal Communications Commission (in 47 CFR 15.105) has specied that the following
notice be brought to the attention of users of this product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and the receiver.
● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface cable
is required to comply with the Class B limits of Part 15 of FCC rules.
Modications (part 15.21)
Any changes or modications made to this device that are not expressly approved by HP may void the user’s
authority to operate the equipment.
ITWW Informazioni normative 181