User manual
●
Meddelande till användare i Japan
●
Meddelande till användare i Korea
Exponering för radiofrekvent energi
VIKTIGT: The radiated output power of this device is far below the FCC radio frequency exposure limits. 
Nevertheless, the device shall be used in such a manner that the potential for human contact during normal 
operation is minimized. This product and any attached external antenna, if supported, shall be placed in such 
a manner to minimize the potential for human contact during normal operation. In order to avoid the 
possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be 
less than 20 cm (8 inches) during normal operation.
Meddelande till användare i Brasilien
Este equipamento opera em caráter secundário, isto é, não tem direito à proteção contra interferência 
prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência em sistemas operando em 
caráter primário.
Meddelande till användare i Kanada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and 
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio 
interference to other users, the antenna type and its gain should be so chosen that the equivalent 
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the 
following two conditions: (1) this device may not cause interference, and (2) this device must accept any 
interference, including interference that may cause undesired operation of the device.
WARNING! Exposure to Radio Frequency Radiation The radiated output power of this device is below the 
Industry Canada radio frequency exposure limits. Nevertheless, the device should be used in such a manner 
that the potential for human contact is minimized during normal operation.
To avoid the possibility of exceeding the Industry Canada radio frequency exposure limits, human proximity 
to the antennas should not be less than 20 cm (8 inches).
Conformément au Règlement d'Industrie Canada, cet émetteur radioélectrique ne peut fonctionner qu'avec 
une antenne d'un type et d'un gain maximum (ou moindre) approuvé par Industrie Canada. An de réduire le 
brouillage radioélectrique potentiel pour d'autres utilisateurs, le type d'antenne et son gain doivent être 
choisis de manière à ce que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas celle 
nécessaire à une communication réussie.
Cet appareil est conforme aux normes RSS exemptes de licence d'Industrie Canada. Son fonctionnement 
dépend des deux conditions suivantes : (1) cet appareil ne doit pas provoquer d'interférences nuisibles et (2) 
doit accepter toutes les interférences reçues, y compris des interférences pouvant provoquer un 
fonctionnement non souhaité de l'appareil.
AVERTISSEMENT relatif à l'exposition aux radiofréquences. La puissance de rayonnement de cet appareil se 
trouve sous les limites d'exposition de radiofréquences d'Industrie Canada. Néanmoins, cet appareil doit être 
utilisé de telle sorte qu'il doive être mis en contact le moins possible avec le corps humain.
An d'éviter le dépassement éventuel des limites d'exposition aux radiofréquences d'Industrie Canada, il est 
recommandé de maintenir une distance de plus de 20 cm entre les antennes et l'utilisateur.
116 Bilaga A Teknisk information SVWW










