HP ZBook Studio G3 Mobile Workstation - Maintenance and Service Guide

1. Disconnect the following cables from the system board:
(1) Right speaker cable
(2) Fingerprint reader cable
(3) TouchPad cable
(4) LED board cable
(5) RTC battery cable
(6) Left speaker cable
2. Remove the seven Phillips PM2.5×4.0 screws (1).
3. Remove the two Phillips PM2.5×4.0 shoulder screws (2).
4. Lift in the middle of the board until the connectors disengage from the left side of the computer (1).
48 Chapter 6 Removal and replacement procedures for authorized service provider parts