HP Spectre x360 Convertible PC Model numbers: 13-w000 - 13-w099 Model numbers: 13-ac000 - 13-ac099 Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement preliminary requirements
- Removal and replacement procedures for Authorized Service Provider parts
- Using Setup Utility (BIOS)
- Using HP PC Hardware Diagnostics (UEFI)
- Specifications
- Backing up, restoring, and recovering
- Power cord set requirements
- Recycling
- Index
Solid-state drive
Description Spare part number
Solid-state drive, PCI 3x4, NVMe, TLC for use in 13-w000 – 13-w099 models
1-TB 865697-001
512-GB 847110-009
256-GB 847109-011
128-GB 912322-002
Solid-state drive, PCI 3x4, NVMe, TLC for use in 13-ac000 – 13-ac099 models
1-TB 865697-005
512-GB 847110-014
360-GB 917818-009
256-GB 847109-016
128-GB 912322-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 24).
5. Disconnect the battery cable from the system board (see Battery on page 26).
Remove the solid-state drive:
1. Remove the PM2.0×3.0 screw (1) that secures the solid-state drive to the computer. (The solid-state
drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Solid-state drive 29