HP PageWide P779, E75160, P75250, P77440, E77650, E77660, P77940, P77950, P77960 - On-Site Installation Guide
Procedure
●
Pre- Requisites
●
Late point dierentiation conguration (LPDC) (automatic)
●
Late point dierentiation conguration (LPDC) (manually using USB ash drive)
●
Install the model nameplate and barcode label
Pre- Requisites
Before performing the procedure, make sure to note the following tasks:
● The LPDC procedure has two components that must be performed by a trained person during the device
install, staging or setup process.
● Wait 24-48 hours from the time the unit is shipped to when the license becomes available in the cloud. The
speed cannot be set until the license is available from the cloud.
● If no internet connection is available, or the LPDC process is not possible via the network connection, the
speed license can be downloaded to a USB ash drive and manually installed.
Ensure that only the power cord is connected. Do NOT connect the network cable until instructed.
CAUTION: Connecting the network cable too early might cause the printer to hang or become corrupted.
Late point dierentiation conguration (LPDC) (automatic)
1. Install all hardware and accessories with the printer power source and the network cable disconnected.
2. Plug only the power cord.
NOTE: Do not connect the network cable.
3. Press the power button to turn on the printer. Wait for the Setup Wizard to display, and then congure each
setting.
4. Allow the printer to nalize the initialization and internal communications.
5. Print a Conguration Page to ensure that the printer is working properly, and make sure that the rmware
is correctly upgraded.
Conrm that the LPDC status is “Not congured (XX, XX, XX)”.
CAUTION: Do not skip the next step.
6. Manually upgrade the printer rmware by using a USB ash drive (do not connect a network cable).
CAUTION: Make sure that all of the accessories are installed before upgrading the rmware. This is the
only way to upgrade the rmware on the accessories. Accessories might not upgrade automatically, if
attached later.
7. Wait for the printer to complete the rmware upgrade process.
ENWW Procedure 105