HP PageWide P779, E75160, P75250, P77440, E77650, E77660, P77940, P77950, P77960 - On-Site Installation Guide

1. Make sure that the network cable is disconnected from the printer.
2. Turn on the main power switch (near the power cord), and then press the power button on the front of the
printer to turn the power on.
3. Download the speed license to a USB ash drive.
4. Press the power button on the front of the printer, wait for it to power o, and then turn o the main
switch on the lower-right side of the printer.
5. Download the speed license to a USB ash drive.
a. With an Internet-connected PC, open a browser and go to the HP JetAdvantage Management (JAM)
Activation site (https://activation.jamanagement.hp.com/) and select the region.
b. Select the country/region.
c. Select SIGN IN on the Partner First Portal..
d. Type the HP Passport Sign In credentials including UserID and Password.
e. Select Managed Print Specialist, and then select Technical Support.
f. Select Activate License, and then search for License.
g. Enter the Serial Number, Printer Product Number, and then select Submit.
h. Select the Get License button next to the device serial number to download the LPDC license le.
NOTE: If the license is not found, contact your distributor to ensure HP has been sent the
information to create the license. When HP has created the license, you will need to wait 24 - 48
hours before the license becomes available in the cloud.
CAUTION: Licenses must be saved in the root directory of the USB drive with the specied le name.
i. Save the le to the root directory of a USB ash drive that has been FAT32 formatted.
6. Transfer the license information to the printer.
a. Insert the USB ash drive into the walkup USB port on the printer (formatter or HIP USB).
NOTE: Make sure that the control panel acknowledges that a USB ash drive is installed (a quick
message appears on the control panel). Then, press the power button on the front of the printer to
turn the power o.
b. Press the power button to turn on the printer, and then wait for the printer to arrive at a Ready state.
NOTE: If the USB ash drive is not detected, remove the USB ash drive, turn o the printer, reinsert
the USB ash drive, and then try again.
c. Wait for the LPDC process to complete (1 to 2 minutes).
d. Wait for the printer to reboot automatically.
e. When the Setup Wizard displays, re-congure each setting.
7. Wait another 5 minutes to allow the printer to nish the LPDC process.
NOTE: Do not turn the printer power o during this time.
ENWW Procedure 107