HP EliteBook Folio 1030 G1 Notebook PC - Maintenance and Service Guide

Display assembly
This section describes removing components that require you to completely remove the display panel. You
can remove the display bezel, webcam, and display panel without removing the entire display hinge-up from
the computer.
Before removing the display assembly, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 24).
5. Disconnect the battery cable.
Remove the display assembly:
1. Open the computer and position it with the base enclosure on a table and the display hanging down.
2. To remove the left display bracket, remove the cable from the bracket (1).
Component replacement procedures 35