HP EliteBook Folio 1030 G1 Notebook PC - Maintenance and Service Guide

Fingerprint reader board
Description Spare part number
Fingerprint reader board (includes cable) 790074-001
Before removing the ngerprint reader board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 24).
5. Remove the battery (see Battery on page 43).
Remove the ngerprint reader board:
1. Disconnect the cable from the system board (1).
2. Remove the Phillips PM2.0×2.0 broadhead screw (2) that secures the assembly to the computer.
3. Remove the bracket from atop the ngerprint reader board (3).
The ngerprint reader bracket is available in the Bracket Kit using spare part number 842302-001.
4. Remove the ngerprint reader board and cable from the computer (4).
Reverse this procedure to install the ngerprint reader board.
Component replacement procedures 45