Configuration Guide
Table Of Contents
- HPE Edgeline EL300 Converged Edge System Setup and Configuration guide
- Contents
- Overview
- Setup and configuration
- Components and site requirements
- Hardware options installation
- Wireless network kit and antenna installation
- System mount options
- Associated hardware procedures
- Installing the power supply
- Powering up the system
- Powering down the system
- Mounting the system
- Dismounting the system
- Removing the antenna
- Removing the brackets
- Removing the security cover
- Installing the security cover
- Removing the drive cage cover
- Installing the drive cage cover
- Removing the heatspreader
- Installing the heatspreader
- Configuration
- Quick task: Be prepared
- Connecting to HPE iSM the first time
- iSM web interface
- Quick task: Configure the network connection and install an operating system
- iSM Network Port-Network Summary
- Viewing installed firmware information
- Boot order
- Managing the system power
- Prepare the system for daily use after installing an operating system
- iSM licensing
- Registering the product
- Troubleshooting
- Warranty and regulatory information
- Warranty information
- Regulatory information
- Belarus Kazakhstan Russia marking
- Turkey RoHS material content declaration
- Ukraine RoHS material content declaration
- Federal Communications Commission notice for Class B equipment
- European Union (CE) compliance
- Canada, Industry Canada (IC) Notices
- Japanese certification mark for 3G module
- People's Republic of China power input cord
- Electrostatic discharge
- Specifications
- Websites
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
Hardware options installation
This chapter provides detailed instructions on how to install hardware options.
For more information on supported options, see the product QuickSpecs on the website at:
http://www.hpe.com/info/qs
To view the warranty for your server and supported options, see Warranty information on page 76.
Power adapter option
The HPE Edgeline EL300 Converged Edge System supports the HPE EL300 80W 12 VDC power adapter
option. This option is supported only when the system is installed with the HPE EL300 12V DC Transfer
board.
Installing the power adapter option
Procedure
Connect the power adapter to the EL300 system.
The installation is complete.
SD card option kit
The system supports installation of an 8 GB SD card.
Installing the SD card option
Prerequisites
Before you perform this procedure, make sure that you have the T-10 screwdriver available.
Procedure
1. Remove the SD port cover from the rear panel of the system.
Hardware options installation 19