Configuration Guide
Table Of Contents
- HPE Edgeline EL300 Converged Edge System Setup and Configuration guide
- Contents
- Overview
- Setup and configuration
- Components and site requirements
- Hardware options installation
- Wireless network kit and antenna installation
- System mount options
- Associated hardware procedures
- Installing the power supply
- Powering up the system
- Powering down the system
- Mounting the system
- Dismounting the system
- Removing the antenna
- Removing the brackets
- Removing the security cover
- Installing the security cover
- Removing the drive cage cover
- Installing the drive cage cover
- Removing the heatspreader
- Installing the heatspreader
- Configuration
- Quick task: Be prepared
- Connecting to HPE iSM the first time
- iSM web interface
- Quick task: Configure the network connection and install an operating system
- iSM Network Port-Network Summary
- Viewing installed firmware information
- Boot order
- Managing the system power
- Prepare the system for daily use after installing an operating system
- iSM licensing
- Registering the product
- Troubleshooting
- Warranty and regulatory information
- Warranty information
- Regulatory information
- Belarus Kazakhstan Russia marking
- Turkey RoHS material content declaration
- Ukraine RoHS material content declaration
- Federal Communications Commission notice for Class B equipment
- European Union (CE) compliance
- Canada, Industry Canada (IC) Notices
- Japanese certification mark for 3G module
- People's Republic of China power input cord
- Electrostatic discharge
- Specifications
- Websites
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
Procedure
1. Install the security cover:
a. Align the pins on the security cover with the openings on the system.
b. Install the screws on the security cover and secure it to the system.
2. Install the preferred bracket option.
3. Install the antennas.
4. Do one of the following:
• Mount the system on wall.
• Mount the system on rails.
5. Connect the power cord to the system.
52 Associated hardware procedures