ProLiant DL385 Gen10 Plus Server

QuickSpecs
HPE ProLiant DL385 Gen10 Plus Server
Technical Specifications
Page
40
System Unit
Dimensions
8.73 x 44.54 x 71.1 cm
3.44 x 17.54 x 28 in
SFF Drives:
8.73 x 44.54 x 74.9 cm
3.44 x 17.54 x 29.5 in
LFF Drives:
Weight (approximate)
Minimum:
15.1 kg / 33.25 lbs with 1
hard drive
Maximum:
19.7 kg / 43.50 lbs with
24 hard drives
Minimum: 8 SFF chassis with 1x SFF HDD and 7 HDD blanks, 2x Drive Bay blanks, 1x processor including
standard heatsink, 1x power supply (plus blank), 1x Smart Array, 1x
Riser installed, cables for the above)
Maximum:
24.7 kg / 54.5 lbs with 12
hard drives
Minimum:
17.3 kg / 38.25 lbs with 1
hard drive
Maximum: 12 LFF hard drives (no rear drives), 2x processors, 2x power supplies, 1x Smart Array, 2x Risers
installed)
Input Requirements (per power supply)
Rated Line Voltage
100 to 120 VAC
200 to 240 VAC
BTU Rating
Maximum
For 800W Power Supply: 3207 BTU/hr (at 100 VAC), 3071 BTU/hr (at 200 VAC), 3112 BTU/hr (at 240
VAC) for China Only
For 500W Power Supply: 1979 BTU/hr (at 100 VAC), 1911 BTU/hr (at 200 VAC), 1965 BTU/hr (at 240
VAC) for China Only
Power Supply Output (per power supply)
Rated Steady-State Power
For 1400W Power Supply: 1400W (at 240 VAC), 1400W (at 240 VAC)
For 800W Power Supply: 800W (at 100 VAC), 800W (at 240 VAC), 800W (at 240 VAC) input for China
only
For 500W Power Supply: 500W (at 100 VAC), 500W (at 240 VAC), 500W (at 240 VAC) input for China
only
Maximum Peak Power
For 1400W Power Supply: 1400W (at 200 to 240 1VAC), 1400W (at 240 VAC) input for China only
For 800W Power Supply: 800W (at 100 to 127 VAC), 800W (at 200 to 240 1VAC), 800W (at 240 VAC)
input for China only
For 500W Power Supply: 500W (at 100 to 127 VAC), 500W (at 200 to 240 VAC), 500W (at 240 VAC)
input for China only
System Inlet Temperature
Standard Operating
Temperature
10° to 35°C (50° to 95°F) at sea level with an altitude derating of 1.0°C per every 305 m (1.8°F per every
1000 ft) above sea level to a maximum of 3050 m (10,000 ft), no direct sustained sunlight. Maximum
rate of change is 20°C/hr (36°F/hr). The upper limit and rate of change may be limited by the type and
number of options installed.
System performance during standard operating support may be reduced if operating with a fan fault or
above 30°C (86°F).