User Manual
Table Of Contents
- HPE ProLiant MicroServer Gen10 Plus User Guide
- Contents
- Component identification
- Operations
- Setup
- Hardware options installation
- Cabling
- Software and configuration utilities
- Server mode
- Product QuickSpecs
- Active Health System Viewer
- HPE iLO 5
- Integrated Management Log
- Intelligent Provisioning
- Management security
- Scripting Toolkit for Windows and Linux
- UEFI System Utilities
- HPE Smart Storage Administrator
- HPE InfoSight for servers
- USB support
- Redundant ROM support
- Keeping the system current
- Troubleshooting
- System battery replacement
- Safety, warranty, and regulatory information
- Specifications
- Websites
- Support and other resources
7. Remove the chassis cover.
8. Remove the system board assembly.
9. Remove the expansion slot blank.
Retain the blank for future use.
10. If the expansion board is shipped with an air bale attached, remove this bale from the board.
11. If the expansion board is shipped with a full-height bracket attached, replace it with a low-profile one.
12. Make sure that any switches or jumpers on the expansion board are set properly.
For more information, see the documentation that ships with the option.
13. Install the expansion board. Make sure that the board is firmly seated in the slot.
Hardware options installation
49