User Manual
Table Of Contents
- HPE ProLiant MicroServer Gen10 Plus User Guide
- Contents
- Component identification
- Operations
- Setup
- Hardware options installation
- Cabling
- Software and configuration utilities
- Server mode
- Product QuickSpecs
- Active Health System Viewer
- HPE iLO 5
- Integrated Management Log
- Intelligent Provisioning
- Management security
- Scripting Toolkit for Windows and Linux
- UEFI System Utilities
- HPE Smart Storage Administrator
- HPE InfoSight for servers
- USB support
- Redundant ROM support
- Keeping the system current
- Troubleshooting
- System battery replacement
- Safety, warranty, and regulatory information
- Specifications
- Websites
- Support and other resources
9. Remove the chassis cover.
10. Remove the system board assembly.
11. Proceed to Installing the TPM board and cover.
Installing the TPM board and cover
Procedure
1.
Observe the following alerts:
CAUTION: If the TPM is removed from the original server and powered up on a
dierent server, data stored in
the TPM including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a
dierent orientation might result in damage to the TPM or system board.
2.
Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM
board firmly into the connector. To locate the TPM connector on the system board, see the server label on the access
panel.
58
Hardware options installation