User Manual

CAUTION: The processor assembly must be removed and replaced as a unit. Do not remove the
processor from the carrier.
CAUTION: When handling the heatsink, always hold it along the top and bottom of the fins. Holding
it from the sides can damage the fins.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to
the socket or processor, do not touch the contacts.
2. Power down the server (Powering down the server on page 30).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 30).
b. Remove the server from the rack (Remove the server from the rack on page 31).
5. Remove the access panel (Remove the access panel on page 31).
6. Observe the following cautions.
CAUTION: Be sure to loosen each heatsink nut in the order indicated. Otherwise, damage might
occur to the heatsink or processor.
CAUTION: Install the processor heatsink assembly as soon as possible after removing it. Do not
leave the processor socket unpopulated for extended periods of time.
7. Remove the existing processor heatsink assembly:
a. Allow the heatsink to cool.
b. Using a T-30 Torx screwdriver, loosen the heatsink nuts.
Hardware options installation 109