User Manual

3. Power down the server (Powering down the server on page 30).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 30).
b. Remove the server from the rack (Remove the server from the rack on page 31).
6. Remove the access panel (Remove the access panel on page 31).
7. Install a secondary riser cage:
• Low-profile (Installing a secondary low-profile PCIe slot riser cage option on page 90)
• Full-height (Installing a secondary full-height PCI riser cage option on page 86)
8. Remove the expansion slot blank:
A T-10 Torx screwdriver is required to remove the expansion slot blank.
• Half-length
92 Hardware options installation